These are the tools we actually use around our house, the ones that show up in project after project. If you’re just getting started, start with the “first five” and add the rest as projects come up.
Some links are affiliate links. If you buy through them we may earn a small commission at no extra cost to you. We only list tools we use ourselves.
Our first five (start here)
- Cordless drill/driver – The tool we grab first on every single project, from hanging shelves to building a hearth.
- Circular saw – Cuts plywood, 2x4s and decking fast. If you only buy one saw, start here.
- Tape measure + speed square – Measure twice, cut once. A speed square keeps every cut straight and square.
- Stud finder – So shelves, TVs and towel bars go into something solid.
- Shop vac – Demo is messy. This keeps the dust and debris out of the rest of the house.
Cutting
- Miter saw – Clean, accurate angle cuts for trim, corner pieces and picture-frame work.
- Table saw – For ripping boards to width and cutting notches, like our corner trim pieces.
- Small bandsaw – Perfect for curves. We cut the legs of our plant stand with ours.
- Wet tile saw – A must for bathroom floors, tub surrounds and even slate stone panels.
- Dremel rotary tool – Small detail work. We carved the wire groove in our driftwood chandelier with it.
- 5″ angle grinder – Cuts off stubborn nails, rusty bolts and metal in seconds.
Drywall, texture and paint
- Drywall knives (6″ and 12″) – Narrow for the first coat, wide for feathering it out smooth.
- Rounded corner bead – Gives windows and corners that soft, finished look.
- Paint sprayer – Paints ceilings and whole rooms in a fraction of the time a roller takes.
- Texture sprayer/hopper – Matches wall texture after repairs so patches disappear.
- Kilz primer – Our go-to primer for walls, ceilings and trim before every paint job.
Air tools
- Air compressor – Powers our nailer and air chisel and blows off dust before finishing.
- Pneumatic finish nailer – Puts up trim fast and leaves tiny holes that are easy to fill.
- Pneumatic air chisel – How we chipped a 10-inch hole through a concrete foundation wall.
Finishing
- Belt sander – Smooths rough boards and trim pieces quickly.
- Sanding sealer – First coat on bare wood so the finish goes on even.
- Clear semi-gloss polyurethane – Protects wood and stone and makes the natural color pop.
- Natural stone sealer – Seals real stone before poly so it lasts.
Electrical and lighting
- Soldering iron – For solid, lasting wire connections on our DIY light fixtures.
- Wire strippers – Clean strips without nicking the wire. A basic for any electrical job.
- GFCI outlets – Required in bathrooms and kitchens; one protects every outlet downstream.
- Fabric-covered pendant light wire – Gives DIY chandeliers that vintage, finished look.
Planning a project? Grab our free Bathroom Remodel Planner. [OPT-IN BUTTON]